Overview
The information here is aimed at connecting a Fysetc Mini v2.1 12864 display but it can also be applied to other 12864 displays (as long as they are ST7567 or ST7920 based).
Board.txt modifications
Add the following lines to the board.txt file
leds.diagnostic = PA_0
lePD_neopixelPin=PF_13
lcPD_lcdCSPin=PH_13
lcPD_spiChannel=3
lcPD_lcdDCPin=PI_10
lcPD_encoderPinA=PI_8
lcPD_encoderPinB=PH_8
lcPD_encoderPinSw=PH_7
SPI3.pins={ PI_9, PB_11, PH_11 }
Config.g
Use this macro to enable the screen.
; ST7567 Init for FYSETC Mini12864 Panel V2.1
; Turn off backlight
m150 X2 R0 U0 B0 S3 F0
; Configure reset pin
M950 P1 C"PI_4"
; hardware reset of LCD
M42 P1 S0
G4 P500
M42 P1 S1
; Turn display on
M918 P2 C30 F1000000 E4
; Fade in backlight
while iterations < 256
m150 X2 R255 U255 B255 P{iterations} S1 F0
G4 P20
; flash Button 3 times
while iterations < 3
m150 X2 R255 U255 B255 P255 S1 F1
m150 X2 R0 U255 B0 P255 S2 F0
G4 P250
m150 X2 R255 U255 B255 P255 S1 F1
m150 X2 R0 U255 B0 P0 S2 F0
G4 P250
; Display "ready" button state
m150 X2 R255 U255 B255 P255 S1 F1
m150 X2 R255 U0 B0 P255 S2 F0
Menu Files
Menu files must be uploaded to allow the display to generate the correct information. This can be done in two ways. First, obtain the recommended menu files from here
Method 1 - WiFi Mode only
Extract the contents of the zip file you downloaded above and place them in a folder called “Menu” on the SD card of the .
Method 2
Activate the display using the config.g changes above.
On the “System” tab, above the list of files, is a dropdown menu that defaults to “System Directory”. Select this and change it to “Menu Directory”.
Then upload the menu zip file.
Troubleshooting
If the screen is showing artifacts/random characters on the screen, the following may improve/eliminate the issue
- Lower the SPI frequency by half. This is the F value in M918.
- Reduce the length of the cable between the screen and the board.
- Ensure that the cable between the screen and the board is routed away from other cables, especially motor cables.
- Add a ferrite ring to the cable between the screen and the board.