Overview
This page covers any general information for the BTT Octopus Pro v1.0 F429 Version board, which is supported from 3.3.0_11.
Driver Jumpers
The jumpers should be installed as below. “SPI mode Interpolation” is supported for TMC5160 drivers. “UART mode Interpolation” should be used when using smart drivers (i.e. TMC2208, TMC2209, TMC2225 and TMC2226)


Driver Diag Pin
If you want to use sensorless homing, a jumper needs adding next to each appropriate endstop as shown below.

Driver Voltage
If using the drivers with 12/24v, then the jumpers for each driver should be configured as below.

If using the drivers with 60v, then the jumpers for drivers that support up to 60v should be configured as below.

Fan Voltage
The fan outputs can each be set to 5v, 12v or VCC.
To set them 5v, set the jumpers as below.

To set them 12v, set the jumpers as below.

To set them VCC, set the jumpers as below.

Initial Installation
Follow the WiFi instructions or SBC instructions