Connecting an accelerometer to a Fly-407ZG

Overview

From 3.3b3_2, an accelerometer can be connected to collect resonance data. Nothing can yet be done with this information but input shaping is expected to be implemented in 3.4. The only type of accelerometers that are supported are LIS3DH (but not LIS3DSH).

Wiring

One possible method of connecting the accelerometer to the Fly-407ZG is described in the table below. The image can be used to aid in identification.
Because the firmware is so flexible and we’re using software SPI, most pins can be used for this.
These connections are on the EXP1 header on the board.

Accelerometer Image Wire Colour Accelerometer Pin Name Accelerometer Pin Type Fly-E3 Pin Fly-E3 Pin Name
Red VIN +5v Input +5v -
Black GND Ground GND -
Yellow SCL SPI SCK E.8  
Green SDA SPI MOSI E.7  
Blue SDO SPI MISO E.10  
White CS Chip Select E.9  
Purple Int Interupt E.14  
LIS3DH Pinout
LIS3DH Pinout

Mounting the LIS3DH

The accelerometer should be mounted firmly to the tool. For a bed slinger (such as an ender 3), it should also be possible to mount it to the bed to take readings for the Y axis.

Boart.txt Changes

Add the following to board.txt

SPI5.pins = {E.8,E.10,E.7}
accelerometer.spiChannel = 5

Config.g Changes

Your config.g should be modified as below.

M955 P0 C"E.9+E.14" I20

The I (orientation) parameter tells the firmware which of the 24 possible orientations the accelerometer chip is in relative to the printer axes. It is expressed as a 2-digit number.
The first digit specifies which machine direction the Z axis of the accelerometer chip (usually the top face of the chip) faces, as follows: 0 = +X, 1 = +Y, 2 = +Z, 4 = -X, 5 = -Y, 6 = -Z. The second digit expresses which direction the X axis of the accelerometer chip faces, using the same code. The direction of positive X is printed on the circuit board. If the board was mounted in the orientation shown in the above image, with +X of the machine being to the right, Y+ being behind and Z+ being up, the I value would be 54. This document gives information regarding the I value for the new Duet toolboard with accelerometer.
20 is the default orientation if no orientation has been specified.

DWC Plugin

There is a plugin to view the accelerometer information. It can be activated under Settings -> General -> Built-in Plugins.
It can then be found under Settings -> Machine Specific -> Accelerometer

Usage

The accelerometer can be activated using M956

Tags: