Release notes for the unstable release of 3.6.0
Duet3D Release Notes for 3.6.0
Please see the Duet3D release notes for 3.6.0 to see whats new and what has been fixed
RepRapFirmware for STM32F4 and STM32H7 Release Notes for 3.6.0 from 3.5.4
- Duet3d 3.6.0
- Added support for Fly E3 Ultra and Fly C5
- Added support for tmcauto driver mode to allow identification of spi/uart drivers
- Added Fly M2 expansion board
- Added support for RP2040 based expansion boards with multiple TMC22xx drivers
- Fix afclite pins
- Report bootloader details in M122 output if it is ours
- New Can capable bootloaders for H7 boards
- Allow update of expansion mode boards over can without an SD card
- Allow CAN address of a board in expansion mode to be changed
- Allow board to be set into expansion mode using board.txt setting
- Improve speed of expansion mode firmware updates over CAN
- Various fixes to board configs
- Use diag LED during firmware updates
- Fix bug with initial reading from probes on expansion boards
- Added bootloader support for H723 based boards
- Fix wrong pin on Afc Lite and tidy up pin files
- Added support for AFC lite board
- Fixed UART data overrun in some situations
- Reduced overhead on gpio interrupt on change
- Added support for FYSETCSB2040V2
- WiFi Firmware v2.2.1
- Fix TMC22xx driver default standstill current (now 100% was 75%).
- Reduce memory usage
- Improved UART driver
- Improved hardware SPI driver