Connecting a 12864 screen to an SKR Pro

Overview

The information here is aimed at connecting a Fysetc Mini v1.2 12864 display but it can also be applied to other 12864 displays (as long as they are ST7567 or ST7920 based).

Wiring

Connect the screen as shown below.

SKR Pro and Fysetc Mini v1.2
SKR Pro and Fysetc Mini v1.2

Board.txt modifications

Add the following lines to the board.txt file

//Fysetc MINI 12864
lcd.encoderPinA=G.11
lcd.encoderPinB=C.4
lcd.encoderPinSw=F.9
lcd.lcdCSPin=D.3
lcd.lcdDCPin=G.13
lcd.spiChannel=3
SPI3.pins={G.14, C.1, F.7} //Set to GPIO pins to use as SCK, MISO, MOSI
//lcd.lcdBeepPin=NoPin

Config.g

Add this line to config.g

M950 P1 C"C.5"
M42 P1 S0
G4 P500
M42 P1 S1
M918 P2 C30 F1000000 E4

Menu files must be uploaded to allow the display to generate the correct information. This can be done in two ways. First, obtain the recommended menu files from here

Method 1 - Wifi Mode only

Extract the contents of the zip file you downloaded above and place them in a folder called “Menu” on the SD card of the GTR.

Method 2

Activate the display using the config.g changes above.
A side menu called “Display” should appear in DWC. Navigate to it and upload the zip file.

Troubleshooting

If the screen is showing artifacts/random characters on the screen, the following may improve/eliminate the issue

  • Lower the SPI frequency by half. This is the F value in M918.
  • Reduce the length of the cable between the screen and the board.
  • Ensure that the cable between the screen and the board is routed away from other cables, especially motor cables.
  • Add a ferrite ring to the cable between the screen and the board.
Tags: